Inovatools Allrounder efficiently mills Inconel and titanium

Editor: Barbara Schulz

For dry-machine Inconel or titanium Inovatools has introduced the Turbomax end mill.

Related Company

Turbomax is available in a range of diameters from 6 mm to 20 mm.
Turbomax is available in a range of diameters from 6 mm to 20 mm.
(Source: Inova Tools)

According to the supplier, it offers increased cost-effectiveness and optimised processes thanks to its special geometry, chip control and coating. The tool is said to be suitable for tool and mould makers, aerospace or automotive applications, among others.

Inovatools treats the Turbomax end mills to the company’s own Naco-Blue coating and an additional end finishing. This smooth high-performance coating is said to allow the chips to flow away very easily and also has a positive effect on the service life of the tools.

Turbomax is available in a range of diameters from 6 mm to 20 mm. The tools are available with HB and HA shanks, and wet and dry machining is possible up to < 1,400 N/mm2 / 45 HRC.

According to Inovatools, depending on the application, the end-mill offers customers a service life up to 2.5 times higher than that of their current end mills.

(ID:43026174)