EMO 2017

Gewefa presents shrink collet system

| Editor: Rosemarie Stahl

The Induterm M96 is based on the heat shrink clamping technique.
The Induterm M96 is based on the heat shrink clamping technique. (Source: Gewefa)

Toolholding innovator Gewefa will have a new taper toolholder on show. Other presented innovations are the Hydropin hydraulic chuck with a fixed stop pin, the Easy Fix boring bar toolholder and a new shrink collet system, called Induterm M96.

The shrink collet system is based on the heat shrink clamping technique, popular for securing milling cutters into tool holders, Gewefa says. The company statest that the Induterm M96 offers exceptional grip with short clamping length. According to Gewefa this provides high flexibility, accuracy, and tool run out of less than 3 microns. Visitors can convince themselves of the cost-effectivness of this solution at EMO 2017.

gewefa.com; Hall 5, Booth B93

Comments are being loaded ....

Leave a comment
  1. Avatar
    Avatar
    Edited by at
    Edited by at
    1. Avatar
      Avatar
      Edited by at
      Edited by at

Comments are being loaded ....

Report comment

Kommentar Freigeben

Der untenstehende Text wird an den Kommentator gesendet, falls dieser eine Email-hinterlegt hat.

Freigabe entfernen

Der untenstehende Text wird an den Kommentator gesendet, falls dieser eine Email-hinterlegt hat.

copyright

This article is protected by copyright. You want to use it for your own purpose? Infos can be found under www.mycontentfactory.de (ID: 44799759 / Machining Accessories )